EdilKamin CHERIE UP H, Инструкция по установке, эксплуатации и обслуживанию

Страница: 48 / 60

48
ENGLISH
USER
INSTRUCTIONS FOR USE
Should this correction not suffice, contact
the Edilkamin-authorised Dealer, to establish
the new operating axis.
Notes on flame variability:
Any changes in the
state of the flame depend on the type of pellets used,
as well as on normal variation of solid fuel flames and
on the periodic cleaning of the crucible the boiler-stove
automatically carries out
(Note: This does NOT replace the necessity cold
vacuuming by the user prior to start up)
.
Environmental temperature control
this comfortable and simple adjustment feature, as
standard in this line of products, allows you to manage
the stove power based on the environmental temperature.
After activating the “Comfort Clima” function from the
parameters menu (ask the technical assistance centre -
TAC), press the SET button briefly a couple of times to
switch from classic “Modulate_Power” mode to “Comfort
Clima” mode; then select the desired mode from the
display.
Modulate power mode
the stove modulates its power by following the output
temperature set by the user.
Comfort Clima mode
the stove modulates its power by following the output
temperature set by the user. You can also use the remote
control as a room thermostat: on reaching the set
temperature the stove will go to minimum power.
Setting the environmental temperature
In “Comfort Clima” mode, by pressing the +/- buttons
on the synoptic panel or on the remote control, you can
set the display to the desired environmental temperature.
-At environmental temperatures below the set
temperature, the stove modulates power normally to
reach the set output.
-With environmental temperature reached (+2°C), the
stove goes to minimum power.
The environmental temperature is transmitted from the
remote control; the remote control transmitter must be
visually aligned with the receiver of the synoptic panel
If the remote control is incorrectly positioned, it cannot
send its recorded temperature. The stove therefore
independently decides to operate at minimum power
and continues thus until the connection with the remote
is restored
Temperature control with external thermostat
another temperature control system is available as an
alternative to the remote control. You can in fact connect
the thermostat serial port to your home thermostat or any
(clean output contact) easily available one
The stove will automatically recognise the connection with
the thermostat serial port under the following conditions:
With environmental temperature lower than the thermostat
setting (contact closed), the stove modulates power
normally to reach the set temperature
-With environmental temperature reached by the
thermostat (contact open), the stove goes to minimum
power
Configuration
Temperature
provided by
the remote
control
Temperature
provided by
external
environmental
thermostat
No adjustment
(factory set-
ting)
"Comfort
Clima"
parameter
ON ON ON
“SONDA IR”
parameter
ON OFF ON
Connection to
serial port NO
no connection
Yes
with blue
serial cable
NO
no connection