EDI TSG-416, Руководство по обслуживанию

Страница: 92 / 228

TSG ‐ 416 ENGINE
02 ‐ 48
ASSEMBLY
NOTE:
All components must be clean and dried with
compressed air or a lint free cloth. For information on
bearings & piston inspection and selection - Refer to
Section 01.
1. Install upper main bearings and thrust washers
to cylinder block. Lubricate the wear surfaces
with clean engine oil. Make sure oil holes align
2. Carefully install the crankshaft onto the upper
bearings.
3. Assemble the lower main bearings into caps.
Lubricate the wear surfaces and the bolt threads
with clean engine oil.
NOTE:
The main bearing caps are numbered and must
be assembled to corresponding numbers. The arrow on
the main bearing caps must point to the front of the
engine.
CAUTION: Use new main bearing cap bolts.
4. Install main bearing caps in the same positions
as removed.
NOTE:
Check the position of studs as shown.
5. Tighten main bearing cap bolts/studs in
sequence shown and in three steps to 70 lb.ft.
(95 Nm).
NOTE:
Check crankshaft end play as outlined in Section
01.