Edgewater Networks 388CC, Руководство для владельца

Страница: 48 / 395

Owner’s Manual
5/8" (1.59 cm) (for a 9" trim tab) and
3/4" (1.9) (for a 12" trim tab) above
the straight edge when held to the
hull (see Fig. 2). When the trim tab
is at the appropriate level, transfer
(trace) the outer shape of the upper
bracket onto the transom. The upper
bracket should be marked where it
lays naturally against the transom
to prevent binding during travel.
(Do not adjust the upper bracket to
the right or left, as this will cause
binding, instead just allow the
bracket to come to rest in it’s natural
position).
Remove the actuator from the
lower bracket. Remove the upper
bracket from the actuator and
align to the previously marked
location to mark the upper screw
hole locations and cable hole
location. Using the 3/16" (.48 cm)
drill bit, drill the previously marked
screw hole locations to a depth of
1-1/4" (3.17 cm).
Note: When drilling out the
screw hole pattern for the trim
tab hinge you may drill through
the transom, however the screws
when installed with 3M 5200
adhesive caulking will seal the holes
when installed. All supplied screws
and fasteners are stainless steel. Do
not use any other type of alloy.
4. Warning: With some installations,
fuel, water tanks and/orother
systems may prevent the actuator
cable from entering the hull through
the upper mounting bracket. Be
sure to check inside the hull before
drilling the 3/8" (.95 cm) cable hole.
If all is clear, Using the 3/8" (.95 cm)
drill bit., drill the previously marked
cable hole completely through the
transom. Insert the actuator cable
through the appropriate hole in
the upper bracket until it reaches
the actuator. Insert the actuator
cable through the gland seal until it
reaches the upper bracket.
Note: For appropriate orientation
of upper bracket and gland seal,
(see Fig 3).
5/8"
(1.59 cm)
14"
(35.56 cm)
max.
height
needed
for
actuator
3/8"
(.95 cm)
9"
(22.86 cm)
3/4"
(1.9 cm)
12"
(30.48 cm)
3/4"
(1.9 cm)
1"
(2.54 cm)
12"
(30.48 cm)
11"
(27.94 cm)
max.
height
needed
for
actuator
13.5"
(34.29 cm)
max.
height
needed
for
actuator
in 9"
(22.86 cm
tab length)
3/8"
(.95 cm)
16"
(40.64 cm)
Standard Mount
Fig. 2
Edge Mount
Fig. 2
Continued on page 10.
9
Fig. 3
Trim Tab Installation Instructions Trim Tab Installation Instructions