Edgewater Networks 188 Center Console 2014, Руководство для владельца

Страница: 14 / 177

13
·
Begin fueling.
·
When the tank is full, stop fueling.
·
Remove the fuel nozzle.
·
Install the fuel cap.
·
Check the area for fuel odors.
Warning: If fuel odors are detected, do not start the engine! Check to make certain there
are no leaks or system problems before starting the engine.
Warning: Do not fill the fuel tank while the engine is running. Do not allow smoking or
open flames within 50 ft. of the fueling area. Fuel is very flammable. To prevent damage to
the engine, use only fuels without harsh additives or alcohol. Refer to your engine owner’s
manual for specific fuel requirements.
4.5 Fuel System Maintenance
Regularly inspect the fuel system components. All lines, fittings, and bulbs should be flexible and
not corroded. If fittings or other components are found to be cracked, they should be replaced at
once. If you use your boat infrequently or do not use it for an extended period of time, a fuel
conditioner should be added to a full tank of fuel to prevent fuel deterioration and damage to the
fuel system.
4.6 Fuel Filters
A fuel filter is installed in the transom area of your EdgeWater 188CC., located
behind the starboard aft access door. This is a fuel/water separator type of filter
and is designed to prevent water from entering your engine. The fuel filter element
is a spin-off type element. At a minimum, this element should be replaced at the
beginning of every boating season. Always carry a filter wrench and spare filter of
the type supplied on your boat.
5/Electrical Systems
5.1 General
Your EdgeWater 188CC operates on a 12 volt DC system, similar to your automobile. The battery
or batteries are typically lead acid type and require similar maintenance to your car’s battery. An
electrical schematic is included in the Appendix for specific location of electrical components.
5.2 Panel Switches
Your EdgeWater 188CC is equipped with panel mounted breakers. On the 188CC, switches are
provided for the navigation lights, decklights, manual bilge pump, livewell, and for the raw water
pump. There are also four accessory switches. A wiring diagram is included with this manual to
assist you in troubleshooting the boat’s electrical system. Please note that the accessory circuits