Edgewater Networks 188 Center Console 2014, Руководство для владельца

Страница: 110 / 177

SEASTAR and BAYSTAR Hydraulic Steering Systems 10-3
To determine the required
hose lengths for outboard
steering installations.
From the illustrations on the following pages (figures A through I),
select the situation which best suits your application and note the:
a) cylinder location,
b) number of cylinders,
c) type of cylinders,
d) number of steering stations, and
e) the number of hose and fitting kits required.
Single Station System
1) From the illustration that suits your application note the number
of hose and fitting kits required.
2) Measure along the intended path of the hose routing for each of
the required hose kits.
3) Round up the measurement to the next even digit and add 2
feet (0.6m). This is the length of hose kit required.
4) Order hose kit(s) par t no. HO51_ _. The last two digits
correspond to the length of hose kit.
a) Measure from center of the cylinder(s) and helm(s)
b) Some installations require more than 1 hose kit and additional
fitting kits (see par ts list for each figure).
c) Minimum bend radius for outboard hose is 2-1/2" (6 cm).
d) Outboard cylinders move. They are subject to engine trim & tilt.
Enough slack must be left in the hoses to prevent kinking.
OUTBOARD HOSE
NOTICE
CAUTION
DO NOT cut the hose. This will destroy the hose. Once cut there is
no means to field swage fittings to the ends of the hose.
PART NUMBER KIT DESCRIPTION
* HO51XX SeaStar Standard Outboard Hose Kit (2 hoses)
* HO57XX SeaStar Pro Hose Kit (2 hoses)
** HO81XX SeaStar Bulkhead Hose Kit, Standard (2 hoses)
** HO82XX SeaStar Bulkhead Hose Kit, Pro(2 hoses)
* SeaStar Standard and Pro Hose Kits are available in lengths from 2' – 30'.
40' Hose Kits are available by special order only.
** SeaStar Standard and Pro Bulkhead Hose Kits are available in lengths from 12' – 30'.
40' Hose Kits are available by special order only.
Available SeaStar
Hose Kits: How to order
NOTICE
Outboard hoses are supplied with
pre- attached hose fittings on
both ends.
In order to prevent hose kinking,
bend restrictors are supplied on
one end of each hose in the kit.
The end of the hose with the
bend restrictor is to be attached
to the cylinder.
Standard Hose Kit
Each part number contains two hoses of equal length.