EdgeStar CWB1760FD, Руководство по обслуживанию

Страница: 29 / 57

8.2 Replacing the Evaporator Fan and Temperature Sensor (CWB1760FD)
1. Remove the back panel from either side of the cabinet by removing the four screws (in red)
holding it in place.
2. Move the panel to the side to access the wire connector for the fan and the wiring to the
temperature sensor.
3. Disconnect fan from wire connector (in yellow) and then remove fan by pulling it from the
rubber plugs holding it to the panel. Replace fan by following these steps in reverse order.
4. Remove the sensor housing from side of cabinet by removing the two screws. Remove
temperature sensor from housing and cut the wires to test it or splice in new sensor. Be
sure and cover any bare wire with electrical tape or heat shrink tubing or condensation from
the evaporator will corrode the wire. Replace the sensor by following these steps in reverse
order. To test a temperature sensor use table 8.2.1 on the next page.
Cut/Splice
Here