Edge-Core EAP101, Руководство пользователя

Страница: 29 / 62

Chapter 2
| Status Information
Wireless Status
– 29 –
■
Radio Status — Shows if the wireless interface is enabled or disabled.
■
IEEE Mode — The 802.11 wireless LAN standards supported by the AP.
■
Op Mode — Shows if the wireless interface is configured to operate in an
access point mode or client mode.
■
Tx Power — The power of the radio signals transmitted from the AP.
■
Channel — The radio channel the access point uses to communicate with
wireless clients. The available channels depend on the 802.11 Mode,
Channel Bandwidth, and Country Code settings.
■
Total Clients — The total number of clients attached to this interface.
■
SSID # — Service set identifier. Clients that want to connect to the wireless
network through an access point must set their SSIDs to the same as that of the
access point.
■
Name — A unique identifier for the local wireless network.
■
Security — Shows whether or not security has been enabled.
■
BSSID — The basic service set identifier. This is the MAC address of the AP
generated by combining the 24 bit Organization Unique Identifier (OUI,
the manufacturer's identity) and the manufacturer's assigned 24-bit
identifier for the radio chipset in the AP.
■
Associated clients — The number of wireless clients associated to the
SSID.
■
Associated Stations — Shows detailed information about associated wireless
clients.
■
Network — The SSID name.
■
Wireless Radio — Specifies the 5 GHz or 2.4 GHz radio.
■
Name — Client name.
■
MAC Address — The MAC address of the wireless client.
■
IP Address — The IP address assigned to the wireless client.
■
Signal — The signal strength (TX/RX) in dBm.
■
Connected Time — The time the wireless client has been associated.
■
Client TX Rate — The data transmit rate to the wireless client.