TriTrax™ 200 Vertical Crawler
Document: UMDT017749.docm
Revision: A02
Created by: JS
Date: 13 Apr 2021
IPN: 3094329-A02
Source Location: C:\ePDM\ISLEng\Products\DT-VersaTrax100MkII\Manuals\UMDT017749.docm
Page 20 of 36
User Ma
nual
Extended Configurations:
To increase the operating size range, install the 50mm (2 inch) or 75mm (3
inch) extension brackets onto the linkages. Note that the extended length track belt is installed for increased
vehicle stability in large diameter pipes.
To install either size of extension brackets, do the following as shown below:
1. Fasten either the 50 (2 inch) or 75mm (3 inch) track spacer to the spacer base using 4x M5x16mm
Flat Head Machine Screws.
2. Attach the Microtrac to the extension bracket using 4x M5x10mm Socket Head Cap Screws.
3. Attach the spacer base to the expansion linkages as detailed in the previous section.
4. Ensure there is enough cable fed through the chassis to plug in the track. Wires can generally be
secured to the long bushing on the driver linkage using a zip-tie.
5. Connect the track connector
– make sure to align the mating pins correctly, and fully engage the
locking collar.
6. Repeat this procedure for each of the other two tracks.
Bracket removal is the opposite of installation
