eddyfi R-Scan Array, Руководство пользователя

Страница: 15 / 31

15
Rear Isometric View
Figure 4: R-Scan Array rear isometic view
11. Probe Lock
Two probe lock levers are used to clamp
the water box securely to the scanner
chassis. One is located at the rear of the
scanner and the other is on right-hand
side.
To engage probe lock : lift the lever up.
To disengage probe lock: push the lever
down.
IMPORTANT
Engage both probe lock levers to
prevent water box movement
12. Magnetic wheels
Four wheels provide a permanent
magnetic attraction to the inspection
surface. The system is supplied with two
different types of wheels. Select and fit
the correct wheels based on the desired
inspection mode.
Manual PA scanning: Requires the high
friction wheel. These are supplied fitted
to the scanner.
Automated PA scanning: Requires the
low friction wheels. These are supplied in
the transit case attached to a magnetic
keeper plate.
CAUTION
Ensure the correct wheels are fitted for
the desired inspection mode.
13. Wheel brake
Used to hold the scanner in position on
the inspection surface. The wheel brake
lever clamps a brake shoe onto the rear
axle of the scanner.
To engage brake : push the lever down.
To disengage brake : lift the lever up.
IMPORTANT
Intended to be used during manual
mode inspections only when fitted
with the high friction wheels.
CAUTION
When used with low friction wheels the
scanner may slide along the surface.
Ensure the brake is disengaged (levers
up) prior to moving the scanner.
Do not engage the brake during
automated scanning.
Excessive brake shoe wear will occur if
the brake remains engaged during
scanning.