Versatrax 300™
Document: UMBH008532.docm
Revision: A07
Created by: KJB
Date: 26 Sep 2019
3047763-A07
Source Location: C:\ePDM\ISLEng\products\bh-vt300series4-trackchassis\manuals\UMBH008532.docm
Page 24 of 67
Versat
rax 30
0 User Ma
nu
al
For IB
A
5954
Sonar Installation
The Imagenex 831A-P profiling sonar is the standard sonar for the VT300
™ system. It is held in front of
the tracks and camera by a bar which provide an unobstructed view of the pipe. The bar bolts on
underneath the camera mount, and the sonar is clamped onto the bar using 4-inch stainless-steel hose
clamps. The sonar is then raised up and down with the camera mount. When the camera extension plate
is used, the sonar can be mounted on top of the bar for greater height.
If a full 360° view is required, the bumper portion on the front of the sonar bracket can be removed by
undoing the two screws at the very front.
Note that other sonar makes may appear different or be held by different brackets.
FIGURE 14: STANDARD SONAR MOUNT
Ethernet
A 6-pin Subconn connector provides a connection for an Ethernet device to be installed on the vehicle.
±15VDC is also provided on this connector to power the Ethernet device. The connection is 100BASE-T
however the maximum data throughput is 10Mbps.
Refer to Section “Fiber Interface Box” for Ethernet connection to a PC or laptop.
