Spectrum 45™ Camera
Document: UMAA007219.docm
Revision: A14
Created by: PV
Date: 08 Dec 2019
IPN: 3041015-A14
Source Location: C:\ePDM\ISLEng\products\aa-spectrum45\manuals\UMAA007219.docm
Page 7 of 16
User Ma
nual
Safety
In order to be able to use this product properly and safely, every user must first read these operating
instructions and observe the safety instructions contained therein. Take care of these operating
instructions and keep them in a place where they can be accessed by everyone.
CAUTION
: Failure to follow these safety instructions may result in injury or
equipment damage.
WARNING:
High Voltage
36-70 VDC.
If the equipment is powered from a
source other than an Eddyfi Technologies provided controller, the power supplied
to the product must have reinforced isolation from the mains with no reference to
earth ground.
CAUTION:
Disconnecting the camera while the power is on can cause damage to
the camera. Disconnect the power source before servicing the product.
WARNING: Spark Hazard
- Under no circumstances should this equipment be
used in a potentially explosive atmosphere.
WARNING:
Intense Optical Radiation
- The Spectrum 45
™ camera lights are
extremely bright. Never look directly at the lights. Use a welding filter (shade #8
or higher) if inspecting the LEDs.
•
The Spectrum™ 45 camera is an industrial product. All personnel operating or maintaining this
equipment must be competently trained.
•
There are no user serviceable parts inside. This product may be serviced only by qualified
technicians or trained personnel.
•
Eddyfi Technologies equipment is used in many varied environments from hot/dry to confined
spaces to deep underwater. Such diverse environment risks must be addressed by the operators
who are trained to work in such surroundings. As such, the operator is responsible to determine
safe site setup and appropriate procedures for operation and maintenance of the equipment.
•
Do not use the product or any component exposed to pressures higher than the rated working
pressure.
•
Do not operate the camera with a damaged connector or cable. Inspect connectors and cables
regularly for damage.
•
Call the Eddyfi Technologies service department for assistance or service if needed.
