4
en
RUCKUS
transmitter
Frequency 2.4GHz
Battery
AA x 4
servo
Power Supply
4.8V~6V (shared with receiver)
Output Torque
41.66 oz (3 kg-cm)
Operating Speed
0.23sec/60 degrees of travel
Size
40.5 x 20 x 36.8mm
electronic speed control (esc)
Input Voltage
7.2–8.4V
Electric Capacity (FET)
Forward 80 A/240 A
Electric Capacity (FET)
Reverse 60 A/160 A
PWM Frequency
1kHz
BEC Voltage
5 V/1 A
Size
27 x 35 x 17.3mm
Weight
34–36 g
sPecIfIcatIons
coMPonents
VehIcle PreParatIons
1
chargIng the VehIcle Battery
1. Connect the AC power cord to the power slot on the charger, then
connect the other end of the power cord to an AC power source.
2. The Power LED and Charging LED will turn GREEN when the
charger is connected to the AC power source.
3. Connect the battery pack connector to the charge connector.
4. Press the On/Off button to charge the battery. The Charging
LED turns RED.
5. When the battery pack is fully charged, the Charging
LED will turn GREEN.
6. Press the On/Off button to stop charging. Disconnect
the battery pack connector from the charge connector.
cautIon:
If at any time during the charge process the
battery pack(s) becomes hot to the touch, unplug the battery
immediately and discontinue the charge process.
The vehicle battery charger produces 2000 milliAmps (2 Amps) per
hour. Divide the mAh capacity on the label of a battery by 2000 to
know how long battery charging will require. For example, a fully
discharged 1800mAh battery requires 0.9 hours (54 minutes) to charge.
1. ECX
™
Ruckus
®
1/10-scale Monster Truck
2. ECX
™
2.4GHz Transmitter
3. AA (4) Batteries
4. DYN4113 2A Peak Battery Charger
5. Dynamite
®
Speedpack
™
7.2V
Ni-MH battery (DYN1050EC)
2
5
3
4
chargIng WarnIngs and PrecautIons
• Read all safety precautions and literature prior to use
of this product.
• Never allow minors to charge battery packs.
• Never attempt to charge dead or damaged batteries.
• Never charge a battery if the cable has been pinched or shorted.
• Never allow batteries or chargers to come into contact with
moisture at any time.
• Never charge batteries in extremely hot or cold places
(recommended between 50–80°F or 10–26°C) or place
in direct sunlight.
• Always use only Ni-MH rechargeable batteries. This charger
cannot charge batteries such as “heavy duty,” “alkaline battery,”
or “mercury battery.”
• Always connect the positive red lead (+) and negative black lead (-)
terminals of the battery to the charger terminals correctly.
• Always disconnect the battery and charger after charging
and let them cool between charges.
• Always inspect the battery before charging.
• Always terminate all processes and contact Horizon Hobby
if the product malfunctions.
• Always make sure you know the specifications of the battery
to be charged or discharged to ensure it meets the requirements
of this charger.
• Never connect more than one battery pack to this charger
at a time.
• Always constantly monitor the temperature of the battery
pack while charging.
• Always end the charging process if the charger or battery becomes
hot to the touch or starts to change form during the charge process.