ECOVACS Winbot 7 series, Инструкция по эксплуатации

Страница: 5 / 60

4
Live Smart. Enjoy Life.
If there is not enough cord, it is not safe to use the WINBOT on that particular window until a WINBOT Extension Cord is
attached (Extension Cord sold separately).
2. Loop one end of the Safety Rope around the Safety Pod's channel and pull it tight.
3. Loop the other end of the Safety Rope to the nut on the power cord and tighten. (If an Extension Cord is attached the
Safety Rope should still be tied to the nut on the power cord.)
Note: Do NOT attach the Safety Rope to the thin part of the cord.
4. Press the Safety Pod suction cup FIRMLY on the inside, lower corner of the window. Make sure the Safety Pod suction
cup is securely in place.
5. Place WINBOT on the window, close the window, and start WINBOT.
6. After WINBOT is done cleaning remove it from the window. Grasp the handle, switch the unit OFF, insert finger into Air
Release Trigger and pull up on it for 20 seconds until suction has diminished.
1. Make sure that there is enough power cord for the WINBOT to clean the entire window without restricting its movement.
Warning
If Winbot is used to clean a window above ground level, the Safety Pod MUST be used.
Winbot must be used in strict accordance with the directions in the Instruction Manual. Ecovacs Robotics, Inc. can not
be held liable or responsible for any damages or injuries caused due to improper use.
Warning
●
●
To safely clean the outside of a window above ground level, the Safety Pod MUST be used. Please read
the instructions on Safety Pod use in this Instruction Manual.
●
To ensure safe operation of the Winbot, the Back Up Battery must be fully charged before use. If the
product has not been used for over a month or the product has alarmed (which consumes the Back Up
Battery
'
s power), please recharge its battery.
●
To safely remove the Winbot from a window, grasp the handle of the unit and move the switch under the
handle to the OFF position (far left). While still grasping the unit, insert finger into the Air Release Trigger
and pull up on it. Remove the unit from the window when the suction has diminished.
When Winbot is working, a person should be in the vicinity to assist should there be a problem.
EN