ECOVACS Winbot 7 series, Инструкция по эксплуатации

Страница: 17 / 60

12. Questions and Answers
11. Back Up Batter y Charge Status
To check the level of your Back Up Battery Charge, connect the Winbot to the Power Adapter and plug the Power
Adapter into an electrical receptacle. Place the Winbot’s switch button, located under the handle, to the CHARGE
position (far right). If the Indicator Light flashes GREEN, the Battery needs to charge. Once the Back Up Battery is
fully charged, the Indicator Light will change to glow a continuous GREEN. You may then use the unit.
16
1.
5
2.
6
3
7
4
Can Winbot fall off the window during section of this Instruction Manual where
cleaning? indicator sounds and lights are covered
in more detail.
Winbot is designed to keep from
encountering situations where it would
Winbot has been placed on the window
lose suction. If the power to the unit fails but is NOT working and the Indicator
during cleaning, the Back Up Battery has Light has not turned BLUE. What does
enough stored energy to keep suction this mean?
until it can be attended to. When
If this occurs, it means that the suction
cleaning the outside of a window higher
power has been compromised. Please
than ground level, the Safety Pod must
examine the Winbot’s Cupule and Driving
be used. The Safety Pod is a second line
Treads for accumulated dirt or dust which
of defense, in addition to the Back Up
would cause the unit to lose suction and
Battery, to prevent the Winbot from falling
stop working. Clean the Cupule and
from a window. The Safety Pod also
Driving Treads in accordance to the
allows for easy retrieval of the Winbot
Product Maintenance section (section 7)
from an outside window.
in this Instruction Manual.
Can Winbot work without someone
Winbot was placed properly to the
present?
window and the START button was
Winbot is designed to clean the window pressed, but the unit moved to the
without a person’s physical assistance. bottom of the window and failed to
However, since the cleaning cycle does work. What happened?
not take a long time, it is recommended
Winbot will not clean the window if it is
that a person remain in the vicinity so
not plugged into a receptacle. Its Back Up
when the Winbot is done it can be
Battery will send the unit to the bottom of
removed from the window and/or
the window and it will go into stand
-
by
attended to.
mode. Should this happen, plug the
Can the product be used on any glass
Power Adapter into a receptacle for
thickness? (windows, sliding glass
power and restart the cleaning cycle by
doors, etc)
pushing the START button on the unit or
on the Remote Control. Make sure that
Winbot can be used on any glass
the Winbot has enough supply cord to
thickness. However, windows with an
clean the entire window without pulling
uneven surface, such as frosted,
on the Adapter.
textured, patterned or leaded glass are
not suitable to be cleaned by the Winbot
What happens if Winbot encounters an
as the uneven surface will cause the unit
obstruction like a window lock or
to lose suction and fall from the window.
handle?
Why does the Winbot send out “toot”
Under normal circumstances, Winbot will
alarm and the Indicator Light flash
automatically maneuver around the
RED after just starting the product?
obstruction and continue its cleaning
process.
Please refer to the Common Malfunctions
.
.
.
.
.
Live Smart. Enjoy Life.
EN