3. Operating and Programming
3.1 Assemble and Charge
Charging Dock Placement
Assemble the Charging Dock and place it on a level floor surface with the base
perpendicular to the ground. Keep the immediate area in front of the charger
(approximately 5 feet) clear of objects and reflective surfaces that would interfere
with the infrared receiver. Plug the Charging Dock in.
Charge the Robot
The START/PAUSE key on the robot blinks when the robot is charging.
Charging normally takes about 3 hours.
After charging finishes, the START/PAUSE key on the robot stays illuminated.
After the robot’s battery is fully charged, DEEBOT’s battery management system will reduce to a trickle charge
to save electricity.
To confirm the robot is charging when it is on the Charging Dock, please make sure the START/PAUSE key is
blinking or stays illuminated.
Turn the switch on the bottom of the robot to the ON position.
Charge the robot at least 12 hours before the first 3 uses.
Place the robot on the Charging Dock making sure the Charging Dock electrode and the Charging Pin on the
robot make a connection.
Automatic Charging
Three Ways to Charge
The robot can perceive a low
battery when it is working, and
will automatically switch to
Back to Charger Mode when
necessary.
You can command the robot
to switch to Back to Charger
Mode at any time with the
Remote Control or the button
on the robot’s control panel.
Command Charging
Manual Charging
Turn ON the power switch on the
bottom of the robot and place it
on the Charging Dock by hand.
Ensure that the Charging Dock
Electrode and the Charging Pin
on the robot make a connection.
Notice
Oper
ation and Pr
og
ramming
8
5 feet
1.7feet
1.7 feet
EN
