ECOVACS DEEBOT D8, Инструкция по эксплуатации

Страница: 12 / 64

3.4 Cleaning Mode Selection
Oper
ation and Pr
og
ramming
11
The robot has several Cleaning Modes for you to choose from to effectively clean all of your floors.
1.7 inch
STA RT
STA RT
STA
RT
START
S TA
R T
STA RT
STA
RT
STA RT
AUTO Cleaning Mode:
This is the most commonly used mode with the largest cleaning coverage.
In Automatic Cleaning Mode the robot will proceed in a straight line until it comes in contact with an obstacle
and then it will change course in a straight line.
If DEEBOT's Dust Sensors detect a lot of dust during its initial route, it will automatically change its path to
fan-shaped or spiral route to clean more effectively.
In Spot Cleaning Mode the robot operates in a “zigzag” pattern from left to right,
focusing on a specific area to clean. After the cleaning, the robot will return to its
starting point and emit a beep.
In Edge Cleaning Mode, the DEEBOT will detect a border, such as a wall, and it will
continue along that path until it meets an obstacle at which point it will alter its
direction.
When the robot works in Intensive Cleaning Mode, it follows the same pattern as
the Automatic Cleaning Mode but performs a more thorough cleaning.
In Intensive Cleaning Mode, the Dust Sensor's sensitivity is increased, so cleaning
is more efficient.
Spot Cleaning Mode:
This mode is applicable for an area of highly concentrated dirt or dust.
This mode is good for aggressive cleaning, or for extremely dirty or dusty floors.
Edge Cleaning Mode:
Intensive Cleaning Mode:
This mode is good for cleaning the edges and corners of a room.
When cleaning a small area like corners or a hallway
in Intensive Cleaning or Automatic Cleaning Mode,
the robot will automatically conduct a “zigzag”
pattern, then will return to the previous mode to
continue cleaning.
Small Areas
When a cleaning time is scheduled in the future, DEEBOT will always work in Automatic Cleaning Mode.
EN