Ecotric FAT26S900, Руководство пользователя

Страница: 10 / 28

10
Pedals Installation
1. Identify left versus right pedal
There is a letter L or R stamped into the axle (threaded part that looks like a screw) as in
Figure 4.1. There may also be labels on the pedals themselves. Please note they are not the
same. Apply a small amount of white grease if possible.
2. Install the left side pedal first
You will have to screw it in counter-clockwise because the threading is the reverse of a normal
screw. Do this by slowly pedalling the crank backwards. If the pedal feels stiff, stop and then
retry. It should feel like a smooth motion. Do not use a wrench until you are ready to tighten it
for the final few turns. Tighten it down until you can’t anymore (Figure 4.2).
PLEASE NOTE:
Hand tightened is not sufficient. Use a wrench. Please ensure that your pedals are
properly tightened before your first ride. If after riding, the threads on your crank are stripped. You have
not followed these instructions. Your crank needs to be replaced and this would not be covered by the
warranty.
3. Install the right-side pedal
This pedal threads in clockwise, like a normal screw. Follow the same principle as discussed in
Step 2 for the left pedal (Figure 4.3).
4. Wipe off any excess grease from around the crank.
Torque Specification Table
Item N.m
Handlebars 18 N.m (Trail Tracker 12 N.m)
Handlebar stem 12 N.m (Trail Tracker 8 N.m)
Seat post Quick release
Seat 18 N.m
Front wheel 18 N.m (if applicable)
Rear wheel 30 N.m or above