EcoQuest SpringHouse, Руководство пользователя

Страница: 8 / 16

8
ASSEMBLING YOUR SPRINGHOUSE FILTERS
WASH HANDS THOROUGHLY AND FREQUENTLY WHILE HANDLING FILTER
CARTRIDGES TO AVOID CONTAMINATING THE CARTRIDGES.
WORK WITH ONLY ONE FILTER CANISTER AT A TIME TO AVOID
MIXING UP THE FILTERS. DO NOT OVER TIGHTEN THE CANISTER.
FILTER CANISTER INSTALLATION
3
3. Wash the inside of the canister using hot
water and a small amount of household
dish washing detergent (automatic dish
washing detergent is best).
Rinse the canister thoroughly using clean
water until all soap residue is removed.
Remove the protective plastic from the filter
which should be marked with the number 1
and place it in the housing.
1
1. Remove the blue filter canisters
(containing the filters) from the boxes.
4
4. Apply a light coat of food-grade lubricant (such as silicone gel) to
the surface of the black O-ring at the top of the housing. This step
is very important and cannot be skipped for any reason.
2
2. Each blue filter canister, black canister cap
(on the unit) and filter is numbered. Take
filter canister #1, remove the filter from the
canister and set aside.
CAUTION:
Do not over tighten
canisters when installing.
5
5. Being careful to match the number on the blue canister with the
number on the black canister head, carefully screw the blue canister
into the black portion of the filter canister. Hand tighten the canister.
Snug with supplied wrench. DO NOT overtighten canisters.
NOTE: FILTER PACKING MUST BE
REMOVED BEFORE INSTALLATION.
6
6. Repeat the installation process, in-turn, for canisters 2, 3, 5, and 7.
Container 6 will contain the polyphosphate granules, see step 7.
NOTE: When a new Carbon or KDF filter is installed, it is strongly
recommended that the 1-micron filter (canister #7) not be installed until
the system is fully flushed as described in item 21 under "Replacing Filter
Cartridges" (page 10). This will prevent premature clogging of the filter.
NOTE: Canister 4
is for the UV lamp.
(See next page)
£ Ó Î
Ç È x {
7
7. For canister 6, clean as recommended for canisters 1, 2, 3, 5,
and 7. Open the bag of polyphosphate granules and pour them
into the canister. Install the canister.