Ecoflam MAIOR P 500-1 PRE, Руководство по эксплуатации

Страница: 15 / 32

EXHAUST GAS TEST
To ensure an economically efficient and
trouble-free operation of the system it will
be necessary to adjust the burner
specifically in accordance with the furnace
system. This is achieved by means of a
fuel-combustion air compound control unit
which adjusts the burner to ensure a
proper combustion. Exhaust gas tests are
required for this purpose.
The percentage CO2 and O2 and the
exhaust gas temperature will have to be
measured to determine the efficiency and
combustion quality.
Prior to any measurement make sure to
check the boiler and exhaust gas system
for absence of leaks.
Recommended combustion parameters
Ratio between O
2
- and CO
2
-
for natural gas H (CO
2
max = 11,7%)
Ratio between O
2
- and CO
2
-
for light oil EL (CO
2
max = 15,40%)
Ratio between O
2
- and CO
2
-
for heavy oil S (CO
2
max = 15,60%)
O
2
= 21 CO 2
max - CO
2
gem = %
CO
2
max
WARNING: if the installation is above sea level the output of the burner
vary base on the diagram.
The regulation of the burner in this case shall take into account the
reduced power of the burner due to the missing air.
Fuel
Recommended
(%) CO2
Recommended
(%) O2
Natural gas 10 ÷ 9 3,1 ÷ 4,8
Light oil 13 ÷ 11,5 3,3 ÷ 5,3
Heavy oil 12,5 ÷ 11 4,2 ÷ 6,2
0
0
5 00
1000
1500
2000
2500
3000
3500
4000
4500
5000
5 10 15 20 25 30 35 40 45 50
M e a n a ir pressure vs . a ltitude a bove se a -level
F a n ca p ac ity redu c ed by [%]
A
ltitude of inst
a
ll
a
tion site [
m
]
CO
2
gem = % CO
2
measured on dry flue gases
420010813300
EN
www.ecoflam-burners.com 15
Secondary air will falsify the measured
results
Check that the exhaust gases have a
residual oxygen (O2) content as low as
possible and a carbon dioxide (CO2)
content as high as possible.
The carbon monoxide content of the
exhaust gases must be below the currently
applicable specifications in all load stages.
In the fuel oil combustion mode the
permissible soot number in the exhaust
gas is not allowed to be exceeded