5
Expansions
19. Connect the new ecoBatteryModule to the ecoBatterySystem power cables:
°
Black power cable to black connection
°
Red power cable to red connection
°
The power cables should click audibly into place and fit securely in the notch. Pull on the
power cable firmly to check.
20. Press the white push-button on the master.
✓
The master activates all the slaves (this takes a few seconds).
INFORMATION
If the ecoBatteryModules power off, press the white push-button again.
✓
The LEDs will light up in green, red and blue depending on their SOC, as shown in the image
below.
INFORMATION
The new ecoBatteryModule will only be charged when the previous ecoBatteryModules
have the same SOC as the new ecoBatteryModule. In the meantime, the remaining
ecoBatteryModules operate at reduced power and a warning is visible on the display. This
display goes off as soon as all ecoBatteryModules have the same SOC.
✓
All LEDs light up in green when all ecoBatteryModules have reached the same SOC.
21. To be carried out by two people: Refit the control plate.
22. Reattach the cables and connectors to the control plate.
23. Refit the connections for the ecoBatterySystem.
✓
The new ecoBatteryModule is installed.
✓
For the next steps, see see chapter 4.5 "Setting up the ecoBatterySystem"
INFORMATION
The parameters must not be adjusted.
32
TM_ecoBatterySystem_2.2_en-UK
Содержание ecoBatterySystem
Страница 4: ...Content II TM_ecoBatterySystem_2 2_en UK ...