USING yOUR
SMART THERMOSTAT
The bright, easy-to-read and easy-to-use touch screen
interface on your Smart Thermostat makes it simple to
review and adjust the settings any time you want.
Adjusting temperature
You can easily adjust the temperature without changing
the thermostat’s programming.
Once you’ve adjusted the temperature, the slider
changes to indicate that you are currently holding
the set temperature rather than running a program.
The Smart Thermostat will hold the new temperature
for the duration you specified in the
Hold
Action option
during the initial setup (see
Holding Action
pg 11) or until
you press
Resume
.
If your system is enabled for auto-change over mode,
and you have selected Auto in the
Details
- System
mode, an arrow will be displayed on the temperature
scale, in addition to the magnifier. This will allow you to
adjust both the heating and cooling set temperatures.
Pressing the arrow will switch the magnifier to that
location and allow you to change that temperature.
There is a minimum difference allowed between
the heat set temperature and the cool set temperature.
If you change the temperatures such that this minimum
is not maintained, the system will automatically adjust
the other set temperature to compensate. Auto-change
over mode and the minimum temperature difference is
configurable in the installer settings.
Viewing Details
The
Details
screen lists various temperature, humidity and
equipment details associated with your Smart Thermostat.
21
C
urrent Temperature
The temperature in the room where the Smart Thermostat is installed.
System Mode
Displays the mode your system is operating in. Press this item to
display a list of options:
Cool
The system will turn on the air conditioner when the current
temperature rises above the set temperature.
Heat
The system will turn on the furnace when the current
temperature drops below the set temperature.
Auxiliary Heat Only
The system will only use the auxiliary or
backup heat source to maintain the heat set point temperature
Auto
The system is in Auto-changeover mode and will activate
the heating or cooling systems to keep your home within the
desired range of set temperatures. This option is only available if
enabled by the installer.
OFF
The system is off and will only display the current temperature.
Fan Control
Displays the current furnace fan setting. Press this item to
toggle between:
ON
The fan runs all the time regardless of programming or if there is a
call for heat or cool. The fan will also run if the System Mode is Off.
Auto
Turns on the furnace fan when the system is heating, cooling or
ventilating your home, or to satisfy the minimum fan on time.
Minimum On Time
This feature allows you to determine a minimum
time per hour that the furnace fan will run. This results in optimal air
circulation and a more consistent temperature within the home. This is
more cost effective than choosing the On position for the fan
Current Humidity
Displays the current percentage of relative humidity measured
in the room where the Smart Thermostat is installed. Humidity
displays even if your Smart Thermostat has not been configured to
control a humidifier or dehumidifier.
Humidifier | Dehumidifier
Humidity is an important factor in your overall comfort level.
If your Smart Thermostat was configured to control a humidifier or
dehumidifier, you will be able to select the options below to control
the level of humidity in your home.
22
To adjust the temperature:
Use your finger to
press and move the
set temperature slider
left or right until the
value in the magnify-
ing lens displays the
temperature you
want.
tapping either end of
the temperature scale
will move the slider by
1° (0.5’ C).
To access your Details:
From the Home
screen, press
Details.