COMFORT DUO RF
5
6 Temperature Reading calibration
Temperature Offset is a feature that lets you adjust the
room temperature r/- 3.5°C. This helps if your
thermostat is in a slightly warm or cold spot. To update
the room temperature reading using Temperature
Offset:
Press
to save the changed value. Press
key to "CONT" setting; or press
to return to
Run PROG mode.
7
LCD Brightness
This function can adjust the
brightness of your device. Press
to enter “LCD Brightness” setting.
Press the buttons
to select
your preference (1~10).
Press
to save the setting and
press
key to enter “RF-home
code” setting” setting.
8
RF Home code settings
This function can adjust the Home
code of your device. Press
to
enter “RF-Home code” setting.
In order to pair with COMFORT DOU
RF-RV, please keep the home code
at 0.
Press
key to save the setting and press
key
to enter “RF-Room code” setting.
9
RF Room code settings
This function can adjust the Room
code of your device. Press
to
enter “RF-Room code” setting.
In order to pair with RV-receiver,
please set a code from 0~15.
Attention!
After setting the room code, please
remember to set the dip switch on RV-receiver. For dip
switch setting, please refer the form below:
Press
key to save the setting.
10
Test RF signal strength of location
1. To test your devices’ location are good or not.
2.. When the ventilation is off, press the fan button
twice so that the intensity of the signal appears on
the screen.
3. RF strength range: 0 ~ 15.
NOTE: Above 8 is better. *It displays only 3 secs.
4. Return to the ventilation mode as it was.
11
Factory default settings
This function will clear all custom settings and the unit
will be restored to factory default settings.
A. Press
key to enter standby (System Off) mode.
B. Press and hold
first then press (6) function key
to enter "F RESET" as the fig. below:
Press the key
to restore factory
default settings.
Press the key
to cancel the
factory reset function and return to
standby mode.
Attention!!
If you press
key, all the custom
programs and option settings (except DATE and TIME
settings) will be cleared.
