Eco EASYPELL EPA 09, Руководство по установке, Страница: 24 / 64

7.3 Requirements on the installation site
The EASYPELL heat pump is designed for outdoor installation. The housing is made
of weather-resistant materials.
• The heat pump must be installed outdoors on a level and stable surface.
• The installation site must have sufficient load-bearing capacity.
• If it is installed in an open area where it may be exposed to the main wind direc-
tion, we recommend installing wind protection devices.
The wind can influence the fan speed.
• The air blown out can cause ice to form, so it must not flow onto sidewalks, terra-
ces, etc.
• The distance to the neighboring properties, houses and gardens should be taken
into account according to the notes on noise development. Any suitable noise
reduction measures should be installed.
• Do not install the heat pump at an angle to the building. This can prevent air cir-
culation.
At the same time, the noise level is greatly increased by the sound reflection from
the walls.
• The noise level should be taken into account when installing next to windows and
doors.
• Installation in depressions or between walls can lead to an air short circuit (cold
air re-circulation).
• The air flow (supply and exhaust air) must not be obstructed under any circum-
stances.
• The condensation water from the evaporator must be able to drain properly.
• The heating water supply pipe should be as short as possible and must be profes-
sionally protected above ground from the risk of frost by appropriate insulation.
• Ensure good accessibility for maintenance and service purposes during installa-
tion.
• Observe the specified minimum distances.
24 7 Installation
Installation Manual