Eco EASYPELL EPA 09, Руководство по установке, Страница: 22 / 64

7 Installation
The following general information describes the installation of the heat pump.
Read and follow all warnings and instructions before installing this product.
7.1 Installation Requirements
The following components are required and must be provided by the installer:
• Sanitary fittings
• Level substrate for sufficient drainage
• Ensure that a suitable electrical supply line is available, see type plate of the heat
pump for electrical specifications. Please observe the specified rated current.
• No junction box is required on the heat pump; the connections are made inside
the heat pump.
• The pipes can be attached directly to the jacket of the heat pump.
• It is recommended to use PVC pipes for laying the electrical supply line according
to local electrical regulations.
• The water pipes should be insulated due to heat loss and frost protection.
The installation of shut-off valves at the water inlets and outlets is recommended!
The installation of a drain valve at the water return (lowest point) is recommended.
Use a booster pump if the water pressure is low.
A filter is required on the water supply
22 7 Installation
Installation Manual