Installation
Connecting panels together
Magen eco-Spark
®
Installation manual. © 2012, all rights reserved
P a g e
|
22
4
Connect the two headers by inserting the rubber
gasket (O-ring) into the opposite header groove
and fitting the ends of both headers into the PPC
(plastic panel clamp).
6
Interlock the tab in the top half of the clamp with the hole in the
bottom half (120210B), swing the top half (120210T) round over
the headers.
Important:
Make sure that the gasket sits snugly in the grooves
of both headers, and is not squashed or pinched between the
headers, as this could result in leaking.
5
Place the bottom half of the PPC under the header end
of the larger, flat portion facing
away
from the panel.
8
Use channel lock pliers to close the clamp together.
7
Notice that the latch and latch lock are connected (PPC
Latch Set - 120231P). Gently disconnect the two parts from
the small plastic bit holding them together. Discard the small
piece and keep both the latch and latch lock nearby.
