time
Program/Temperature
setpoint
P1 (20
°C)
P2 (21
°C)
P3 (22
°C)
Heating device
ON
Heating device
OFF
time
LEGENDA:
P1
à
7:00h (
ON
)
; 20:00h (
OFF
); temperature setpoint
20
°C
P2
à
9:00h (
ON
); 11:00h (
OFF
); temperature setpoint
21
°C
P3
à
13:00h (
ON
); 17:00h (
OFF
); temperature setpoint
22
°C
5
7
8
9
10
11
12
13
14
15
16
17
18
19
20
temperature setpoint in timer mode
Heating device;
ON
Heating device
OFF
Figure 3:
Programs overlapping
Setting the fuel options
The
Fuel
menu context shows the fuel autonomy and enables you to select the fuel quality. In the combined
wood/pellet combustion systems, you can select the wood or pellet fuel type.
The
Fuel autonomy
value shows how much fuel is left in the container (in days or hours). For example, value 3d means
there is enough fuel for three more days of operation. If you are using the pellet level sensor, the fuel autonomy is
monitored automatically. You can also manually set the fuel autonomy. When you fill the empty container (up to full
level in the magazine), set the fuel autonomy to FULL. The display shows how long the fuel in the container will last (in
days or hours). When there is fuel for less than an hour left, the display shows LO (low). When the container empties,
the Fuel autonomy sets to OFF and icon (no fuel) lights up on user interface. Fill the container and set the
Fuel
autonomy
setting to FULL. If you refill the fuel container before it is completely empty, remember to reset the fuel
autonomy to FULL. Be careful to fill up the fuel to the “full” level in the magazine, otherwise the fuel autonomy will
not display properly.
Note
For the above-mentioned to work properly the combustion device has to support Fuel autonomy
function.
With the combined wood/pellet combustion systems the burning can be performed manually, using the wood fuel, or
automatically, using the pellet fuel. If wood mode is selected, the system burns on wood until the gases temperature
in the burning chamber falls below the set threshold (the wood burns out). Then the combustion system switches to
pellets automatically and operates in pellet mode (option). To switch back to wood mode, set the
Fuel type
option
value to
2
to select the wood fuel type.
You can optimize the burning and feeder options based on the type and efficiency of the fuel used. With the
Fuel
quality
options you can select the level of pellet and wood combustion efficiency, where low value stands for more
humid fuel with less combustion efficiency, and high value stands for fuel with high combustion efficiency. You can
select between values 1 to 3.
