SunTrackerTwo Installation
1
3
7
6
5
4
Place the base of the
vertical post into the hole of
the horizontal support bar
and press down until the
two fit snug. (Make sure
the small set screw on the side of the horizontal support bar is backed
out far enough so as to allow the vertical post to seat down correctly).
While supporting the mirror, pass the
pre-attached bolts of the controller
(and the controllers shaft) through the
three holes in the mounting bracket.
Attach the two remaining black plastic
nuts to the bolts and hand tighten
(do not use a wrench). Please note
that the solar panel of the controller
faces away from the mirror. (The blue
controller is shipped in it’s own box)
Tighten the set
screw (on the side of the
horizontal support bar)
until it is just possible to
rotate the vertical post.
Rotate the vertical post
until the D-flat (see picture
with arrow pointing to
D-flat) is facing true south
(THIS IS IMPORTANT). Once the D-flat is facing true
south, tighten the set screw fully.
7
4
4
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
Place tray assembly into position
(flange resting on top of curb)
5
6
7
8
TOLL FREE:(888)329-2705 [email protected] www.eco-smart.com
PAGE 3
Eco-$mart, Inc.
