Affix dome to the curb by screwing
fasteners through the holes in the frame
(three per side). Recommended fasteners are
#10 hex head Zinc plated screws 1½ inches
long (fasteners are not provided).
When attaching fasteners, take care to drill straight in or slightly downward so
as not to penetrate the interior gutter system of the dome.
SunTrackerTwo Installation
12
2
1
Line up the flat side of the controllers shaft
with that of the D-flat at the top of the vertical
post. Gently push down on the controller until the
shaft is completely inserted into the vertical post.
SLOWLY rotate the controller until the solar panel
(and mirror) is facing the sun. This will allow the
controller to charge properly.
IMPORTANT
— Once the controller / mirror is
in place, care should be taken to not leave the
unit unattended as long as it remains uncovered.
Wind can cause the mirror to spin out of control,
possibly doing damage to the inner workings of
the controller. Cover the unit with the dome before
moving on to install other controllers.
Please note, the unit will need time to properly charge before any movement of the mirror takes place
(this charge time can vary depending on sunlight levels).
Place the dome over the mirror assembly making
sure it is seated down firmly on all sides of the curb.
(As a rule, two persons should be involved when
moving, or working with the dome).
1
1
1
1
1
1
1
2
2
2
2
2
2
2
1
1
1
1
1
1
1
2
2
2
2
2
2
2
9
10
11
TOLL FREE:(888)329-2705 [email protected] www.eco-smart.com
PAGE 4
Eco-$mart, Inc.
