Light Well Assembly and Installation
1
Remove protective film (if there is any)
Make sure the outward facing flange of each section (that will rest on the curb) is on the top, and
the inward facing flange (that will support the bottom lens) is on the bottom (doing a dry fit the first
time to see how the unit should look is recommended).
Before installing any light wells, make sure that all curbs are square over the hole, level at the top
and plum (the same inside diameter top to bottom), and that there are no obstructions intruding
into the space that the light well is to occupy.
If the sections come with pre-attached double-sided tape
for connecting the light well together, peel the outer cover
off the tape of one section.
Butt the flat side of another section into the corner of the
first (and over the tape) making sure the two sections are
even top and bottom before pressing together.
Some suppliers do not provide pre attached tape. If that is
the case, the contractor has the option of using #10, 1/2”
truss washer lath screws with neoprene bonded washer
(screwing from the outside in), or using their own double-
sided tape to connect the light well together.
1
2
3
3
TOLL FREE:(888)329-2705 [email protected] www.eco-smart.com
PAGE 2
Eco-$mart, Inc.
