If there is a need for longer light wells that must match up with drop ceilings, these light
wells will come in eight pieces per well as apposed to the four on standard versions.The
construction of these longer wells is similar to the shorter version.
When laying out the pieces, the upper four sections will have an outward facing flange at
their top (to rest on the curb) and no flange at the bottom.
The lower four sections will have an inward facing flange at their bottom (to support the
lower lens) and no flange on the top. When assembled, you will have two “open ended”
boxes. Measure the correct distance from the top of the curb to where the well is to
meet the drop ceiling. Slide the upper section of the well (non flange side) into the lower
section of the well (non flange side). Slide these sections together until the proper length
is achieved. Connect the two sections together where they overlap with #10, 1/2” truss
washer lath screws with neoprene bonded washer. Use several workers to support the
light well, and set it into the hole and onto the curb.
Proceed to SunTrackerTwo installation manual.
Longer “adjustable” Light Wells
4
3
Light Well Installation (Continued)
TOLL FREE:(888)329-2705 [email protected] www.eco-smart.com
PAGE 4
Eco-$mart, Inc.
