Bedienungsanleitung / User Manual SYNCHRONIKA
ENGLISH
24
Machine in use with direct water connection
1
Plug the machine into an electrical outlet. Place the brew lever into the upper position. Turn the machine on by
placing the metal switch in the upper position. The coffee boiler is now being heated and the green control lamp
will come on. In order to turn on the steam boiler as well, please press the right switch (symbol: steam) located
under the drip tray to position ‘1’. The orange control lamp now lights up. Caution! Please make sure that the
left switch for the direct water connection (symbol: water tap) is in position ‘1’ (image 2, page 22). The machine
is now on, the pump is activated and is filling fresh water into the steam boiler. Both boilers are being heated in
succession.
2
As soon as water is discharged from the brew group, place the brew lever back into the lower position. The
coffee boiler is now filled with water.
3
As soon as the steam boiler is filled with water, no more pump noise will be heard and the PID-display indicates
the current temperature of both boilers (reg. item 3.3). Please wait until the pump pressure gauge indicates a
value of ca. 1.0 – 1.25 bars.
4
A manual boiler venting is not necessary because the Synchronika contains a professional Anti-Vacuum valve,
which vents the boiler during the heat-up phase. This venting procedure is done by way of the discharge behind
the brew group, directly into the drip tray. Caution, steam forms!
5
The machine is now ready for use. Put the cups on the cup heater tray in order to preheat them and enjoy your
coffee.
The SYNCHRONIKA has a fuse to prevent the machine from overfilling.
It is possible that the machine does not heat up when using it for the first time or when dispensing
large quantities of water through the hot water valve. In this case, please switch the machine off and
on again.
Filter holder, drip tray, drip grid and water tank are not suitable for the dish washer.
6 USE OF THE MACHINE
6.1 Preparation of the machine
The switched off machine is to be placed into operation as follows:
Water tank machine or machine in use with water tank
1
Fill the water tank.
2
Make sure there is enough water in the tank.
3
Now turn the machine on (the metal switch in the upper position and the left switch behind the drip tray in
position ‘0’).
4
Please wait until the desired coffee-, i.e. steam temperature, has been reached (value indicated on the PID-
display).
5
In general, the machine will be heated up in about 15 minutes, depending on the ambient temperature.
6
The machine is now ready for use.
7
Prior to preparing your first coffee, insert the filter holder and activate the brew lever in order to release hot
water and to heat the filter holder to an optimal temperature.
Machine in use with direct water connection
1
Please make sure that there is always water pressure in the water connection line.
2
Now turn the machine on (the metal switch in the upper position and the right switch behind the drip tray in
position ‘1’).
3
Wait until the gauge indicates a value of 1.0 – 1.25 bars.
4
In general, the machine will be heated up in about 15 minutes, depending on the ambient temperature.
5
The machine is now ready to use.
6
Prior to preparing your first coffee, insert the filter holder and activate the brew lever in order to release hot
water and heat the filter holder to an optimal temperature.
Содержание synchronika
Страница 1: ......
