(cONTiNUEd)
clean and check the condition of the single internal o-
ring in the front of the oops insert, replace if necessary
(sEE FigUrE 15.5)
. lubricate all three of these o-rings
liberally using eclipse Grease
(sEE FigUrE 15.6)
.
replace the oops insert into the oops body ensuring
that the o-ring end goes in first, pushing it into place
(sEE FigUrE 15.7)
.
lubricate the narrow end of the oops pin with a drop
of eclipse oil and push the pin, narrow end first, into the
oops body so that it sits in the oops insert and pokes
through the front of the oops body
(sEE FigUrE 15.8)
.
screw the oops knob back onto the oops body until
only a couple of threads are showing
(sEE FigUrE 15.9)
.
reconnect the macroline hose to the fitting on the
oops body
(sEE FigUrE 15.10)
.
you have now successfully cleaned and maintained
your on/off purge system.
Fig 15.5
Fig 15.6
Fig 15.7
Fig 15.10
Fig 15.9
ThE gEO ON/OFF pUrgE
sYsTEM (OOps)
having disconnected the macroline hose from the
fitting on the oops body, unscrew the oops knob
from the oops body
(sEE FigUrE 15.1)
. clean off any
dirt, debris or moisture from the oops knob and the
threaded section of the oops body.
use an appropriately sized hex key to push the oops
pin out of the oops body
(sEE FigUrE 15.2)
and them
remove the oops insert using a pair of needle nosed
pliers
(sEE FigUrE 15.3).
clean and check the condition of the two o-rings on
the outside of the oops insert, replacing as necessary
(sEE FigUrE 15.4)
.
Fig 15.2
Fig 15.3
Fig 15.1
Fig 15.4
warNiNg: dE-gas YOUr MarKEr, dischargiNg
aNY sTOrEd gas iN a saFE dirEcTiON, aNd rEMOVE
ThE BarrEl, lOadEr aNd air sYsTEM TO MaKE ThE
MarKEr EasiEr TO wOrK ON.
WARNING
Fig 15.8
M
AI
N
TE
N
AN
CE
70.
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR GEO
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
71.
M
AI
N
TE
N
AN
CE
MAINTENANCE
QUicK gUidE
Содержание GEO
Страница 1: ......
