Ecler WPaBT, Руководство пользователя

Страница: 9 / 19

9
INSTALLATION
The installation of a WPaBT unit consists of the following steps.
6.1. Installation of a single unit, on the surface or flush:
1. Remove the front panel cover, which is held in place by magnets. You can use
the magnet provided as a tool, touching it to the upper right corner of the front
cover and pulling it gently. Take care not to damage the Bluetooth® antenna
2. Connect the audio, GPO control and external power supply (see
CONNECTIONS chapter).
3. Screw the device to the surface box or the flush box.
4. Replace the front panel and attach the rotating encoder knob (see MOUNTING
DIAGRAM chapter).
6.2. Installation of a WPaBT unit, together with an eMCONTROL1 control panel, on
the surface or flush:
Note:
A WPa2FMBOX double box is required in order to mount both devices flush next
to each other, or a WPa2SMBOX double box is required for surface mounting. Both
WPa2FMBOX and WPa2SMBOX are sold separately.
1. Remove the front panel covers from both devices (WPaBT and
eMCONTROL1), which are held in place by magnets. You can use the magnet
provided as a tool, touching it to the upper right corner of the front cover and
pulling it gently.
2. Mount both devices on the WPa2SMBOX or WPa2FMBOX frame. They are
mounted AFTER the frame.
3. Connect the RJ-45 connector of the CAT5 or higher cable, which will run to
one of the REMOTE inputs of the HUB device. If necessary, connect an external
power supply (see
CONNECTIONS chapter).
4. Connect the WPaBT and eMCONTROL1 together using the cable supplied on
both devices (see
CONNECTIONS chapter).
5. Screw the device to the surface box or the flush box.
6. Replace the front panels and attach the rotating encoder knob.