14
OPERATION
WPaBT has a PAIR button and an activity LED on the front panel.
1.
Waiting for connection
: LED flashes once every second (heartbeat). This indicates
that there is no active connection.
2.
Pairing
: To pair two devices, press and hold the PAIR button for approximately 2-
3 seconds. The LED will start to flash rapidly, indicating that the device is now
visible and ready to pair with other Bluetooth® devices. On your Bluetooth®
device (mobile phone, tablet, computer, etc.) go to the Bluetooth® settings and
select the "Ecler-WPaBT" device. WPaBT will remain in pairing mode for one
minute. If no pairing is established after one minute has elapsed, it will return to
the "waiting for connection" state.
3.
Connected
: once the devices are paired, when the connection is established, the
LED will light up continuously. If the connection to the device is lost, it will return
to the "waiting for connection" state.
In addition, the pairing button allows you to:
4.
Disable/Enable LED
: If this feature is enabled, you can disable/enable the LED
when the device is in "waiting for connection" mode or "connected" mode with a
short press of the PAIR button. If the device enters pairing mode, when the
process is finished (whether it is paired or not), the LED will always be in the active
state.
5.
Reset to factory settings
: If this function is enabled, you can press and hold the
PAIR button for approximately 10 seconds to reset it to factory settings. Press and
hold the PAIR button until it stops flashing rapidly and the LED lights up
continuously.
