Ecler MIM088SG, Руководство пользователя, Страница: 9 / 33

9
5.5. ETHERNET port for programming and control
An RJ45 type connector allows connecting the equipment to an Ethernet network:
• Management from EclerNet Manager application. Please refer to EclerNet Manager
Software manual at
www.ecler.com for more information.
• Possibility of direct connection (point to point) between a computer and a MIMO
SG unit.
• Connection to third party other devices. (Crestron, AMX, Vity, Medialon, etc.
Registered trademarks of their manufacturers). Protocol used: Ecler TP-NET.
See
the TP-NET protocol manual for more information.
• Connection to WPNETTOUCH units (remote control of an entire network of
EclerNet devices through custom graphic panels).
5.5.1 Factory Preset Network settings
The factory default network settings for EclerNet Manager compatible devices are as
follows:
• IP: 192.168.0.100
• Mask: 255.255.255.0
• Gate: 192.168.0.1
•
UDP Port: 2210
5.6. REMOTE port for digital remote controls
The REMOTE port allows the connection of digital remote-control
devices, such as the WPNETTOUCH wall panel or the MPAGE16 paging
console. The REMOTE port is connected to the digital control bus the
remote devices are daisy-chained to, the last one being loaded with a
120
 termination resistor between CAN HIGH and CAN LOW.
Refer to the remote device documentation (WPNETTOUCH, MPAGE16, etc) for more
information about your connection and controls.
Please refer to EclerNet Manager Software manual at
www.ecler.com for more
information about programming a MIMO SG to manage the remote devices that are
connected to the REMOTE port.