Ecler MIM088SG, Руководство пользователя, Страница: 7 / 33

7
5.2. Connection to an AC outlet and switching on
All models in the MIMO SG series operate under voltages between 90 and 264 V at 47
to 63 Hz. This device features an over dimensioned power supply that adapts to the
mains voltage in any country of the world with no need to make any adjustments.
On the rear panel, there is a power switch for the unit next to the IEC power connector.
On the front panel, a LED lights up when the unit is switched on.
The mains cables must not be near the shielded cables carrying the audio signal, as this
could cause humming.
5.3. Signal input connections
The rear panel of a MIMO SG unit offers 8 (MIMO88SG) or 12 (MIMO1212SG) balanced
analogue signal inputs, "IN", accepting both line and microphone level signals. Input
signal type selection and management are carried out from EclerNet Manager
application. Please refer to EclerNet Manager Software manual at
www.ecler.com for
more information.
Signal input connectors are 3 position screw terminal block. The wiring is:
Hot or direct signal > Te
Cold or inverted signal > Terminal -
Ground > Terminal ⊥
For unbalanced connection short-circuit pin ⊥ to pin -.
5.4. Audio Output Connections
The rear panel of a MIMO SG offers 8
(MIMO88SG) or 12 (MIMO1212SG) analogue
signal outputs "OUT", all balanced and accepting
line level signals.
Signal output connectors are 3 position screw
terminal block. The wiring is:
Hot or direct signal > Te
Cold or inverted signal > Terminal -