Ecler EVO4, Руководство пользователя

Страница: 13 / 29

13
7. EFFECTS PROCESSORS
7.1. Using the effects processors
The EVO4 comes with two powerful, BPM-synchronized effects processors, EFFECTS 1 and EFFECTS 2.
Both processors work at 96 kHz and 24 bit, and each comes with the 18 different effects, the same number of
controls, a BPM counter and an LCD, where you can see all of the information related to the effects.
The effects processors are fully independent and can be used in three different ways:
With the EFFECTS 1 and EFFECTS 2 processors assigned to different channels. For example, you can
run a Delay on channel 2 with the EFFECTS 1 processor and a High Pass Filter on channel 3 using the
EFFECTS 2 processor. This mode of operation allows for creative song mixing, because you can run
different effects on the two mix channels.
With the EFFECTS 1 and EFFECTS 2 processors assigned to the same channel. For example, you can
run a Delay on channel 2 with the EFFECTS 1 processor and use the EFFECTS 2 processor to run a High
Pass Filter on channel 2 as well. This mode of operation allows you be creative and run two different
effects on the same channel. Each effect can then be adjusted with its own respective controllers.
Linking the EFFECTS 1 and EFFECTS 2 processors. To do so, turn the INPUT encoder to EFFECTS 2
and select the LINK TO FX 1 option. This links the effects of both processors as in the prior example but
uses just one DRY-WET controller (the one for EFFECTS 2) to make it easier to run both effects
simultaneously.
7.2. Effects controllers
Each of the processors includes the effects controllers described below:
TIME UP/TIME DOWN buttons
The TIME UP and TIME DOWN buttons (4, 5) allow you to adjust the time in some effects. To increase the time of
an effect in beats, press UP. To decrease the time of an effect in beats, press DOWN.
These buttons are also used to control the LOOP SAMPLER effect described in section 7.3.
INPUT encoder
The INPUT encoder (6) allows you to assign the effects processor to one of the four channels on the mixer, one of
the two sides of the crossfader or the master.
When turning the INPUT encoder, a menu of available options appears on the screen. To choose one of the
options, turn the INPUT encoder to highlight the option and select it by pressing the encoder.
You can assign each of the effects processors to the following seven options:
CHANNEL 1
CHANNEL 2
CHANNEL 3
CHANNEL 4
XFADER A
XFADER B
MASTER
The EFFECTS 2 processor also includes the LINK TO FX 1 option, which also you to link it to the EFFECTS 1
processor, as described in section 7.1.