Ecler eCA120HZDN, Руководство пользователя

Страница: 6 / 16

6
Dante™ audio inputs
eCA120DN / eCA120HZDN allows the reception of 2 Dante™ audio signals via Ethernet
by means of an RJ -45 connector. Routing of Dante™ audio signals trough the Ethernet
network is achieved thanks to the Dante ™ Controller software. To learn more, check the
developer’s documentation:
www.audinate.com/products/software/dante-controller?lang=es"
Make sure that the front panel switch ( INPUT SELECT ) is in DANTE p osition, and then
adjust the DANTE input gain with the front panel trimmer ( DANTE INPUT ) until the
input audio signal is appropriate.
Analogue audio inputs
eCA120DN / eCA120HZDN input channel only supports stereo line signals (or two mono
signals). It has
an unbalanced stereo connection with dual RCA connector and 3-pin
Euroblock connector ( LINE IN ). This input is designed to support -6dBV to 0dBV signals,
given that the rotary volume control of the front panel provides an extra +6dB of gain at
its maximum position.
This audio input can receive signals from CD players, radio tuners, mixing consoles,
media players, audio outputs of computers and tablets, etc..
LINE IN connections are linked, so that when you use one of them as an audio signal
input for your unit, you can use the other to send that signal to another unit or external
equipment.
Audio output connections
eCA120DN:
The powered output ( OUT L y R ) uses a Euroblock connector.
The connection cable that connects the eCA120DN connectors and the speakers should
be good quality, with a suitable cross section and as short as possible.
Keep in mind that, minimum nominal impedance for each cannel is 4
Ω
. For a proper
performance, the unit must not work under lower impedance than previously specified,
under no circumstances.