Eckman EKPWT1, Инструкция по эксплуатации

Страница: 11 / 18

11
5. Pull on the recoil starter once again. Allow the engine to run idle for around
10 seconds to let it warm up.
6. To speed up, set the Throttle
Switch to the “H” position.
Note: Check the blade to make sure it does not turn when the engine is at idle.
If the blade rotates even a little, using a Philips head screwdriver, lower the
idling speed by adjusting the carburetor as shown below. (turn clockwise to
increase idle speed/counter-clockwise to reduce. Turn in increments of ¼ max.
Stopping the engine:
Warning: Cutting blade will continue to rotate for a few seconds after the
engine has stopped.
1.Release the throttle trigger and allow the engine to idle for a few moments.
2.Move the ignition switch to the off position marked STOP.
Fig.12
Fig.13