7
POLE SAW INFORMATION
POLE SAW ASSEMBLY
(WARNING: Cutting edges on chain are sharp. Use protective gloves when
handling chain.)
1. Lay chain out flat.
2. Turn adjusting screw counterclockwise (
see Figure 1
). Continue to turn adjusting
screw until adjusting block is to rear of adjusting plate.
3. Install guide bar onto saw body. Place rear of guide bar between adjusting plate and
sprocket support.(IMPORTANT: Make sure to insert adjusting block into adjusting
hole on guide bar.)
Figure 1
4.Place chain around drive sprocket, then along top groove of guide bar and around
guide bar nose. Note: Make sure cutting edges of chain are facing the right direction
(
see Figure 16
). Position chain so cutting edges on top of guide bar face guide bar
nose (
see Figure 1
).
5. Adjust saw chain tension. Follow steps under Saw Chain Tension Adjustment.
Figure 2