10
Adjusting Pole Length
The Pole Saw has a telescoping pole assembly that will extend from 1.8 meters (fully
retracted) to 2.7 meters (fully extended). The collet with a locking knob is used to
hold the pole in position at any extended length.
1. To extend the pole, loosen the locking knob(
see Figure 7
). Pole will slide freely.
2. Pull inner pole section out to desired length of extension. Note: Only extend pole to
minimum length required to reach limb that is being cut.
3. To lock pole in position, tighten locking knob (
see Figure 7
).
Figure 7
CUTTING WITH THE CHAIN SAW
1. Fill the oil tank with chain oil.
2. Connect power cord to power supply.
3. Use both hands to grip pole saw.
Use designated grip areas and strap when
operating pole saw.
(See Figure 8)
Use firm grip. Thumbs and fingers must wrap
around pole saw handle and pole.
4. Make sure your footing is firm. Keep feet apart. Divide your weight evenly on both
feet.
Figure 8
