Echoflex Installation Guide
Elaho Vacancy Sensor
Lens Masking
Lens masks are provided in the packaging for your convenience, used to block
a section of the lens from detecting vacancy.
1.
As needed, trim the lens mask to
fit the desired area to be blocked.
2.
Gently press down on the sensor
lens, which will give only slightly,
and insert the lens mask.
3.
Rotate the lens mask around the
dome to block the required area
from sensing.
PIR Detection
The PIR detection automatically adjusts its sensitivity to eliminate nuisance
tripping. When the sensor powers on, the red PIR LED illuminates for
approximately 60 seconds to identify “Power Up” state. Sensor configuration
is not allowed. During this time, no events are triggered.
Test
Vacancy Sensors offer a Walk Test mode which shortens the vacancy timer to
ten seconds, allowing for simple and quick verification of the sensors
coverage and range in the installed space.
Auxiliary
button
Walk Test
button
Walk Test mode automatically exits and the
sensor returns to normal operation after five
minutes and can be manually terminated early
by pressing the [Walk Test] button.
Elaho Vacancy Sensor
Page 9 of 12
Echoflex Solutions, Inc.
