![background image](http://html1.mh-extra.com/html/echo/cs-2511tes/cs-2511tes_service-manual_4129674077.webp)
HANDLE AND CONTROL SYSTEM
CS-2511TES
251Ts, 251TCs
75
9-4 Replacing rear handle and springs (continued)
15. Assemble rear handle (G) to unit.
NOTE :
Make sure to install intake bellows (L) and
intake pipe (M) to rear handle (G).
16. Set hook (j) of spring (J) in rib of engine cover
and lightly tighten (F) as shown.
17. Pushing down rear handle (G) by hand so that
boss (g2) of rear handle (G) touches engine cover
(K) as shown, tighten bolt (H), then bolt (F).
NOTE :
Make sure spring (J) is installed parallel
to line (g3) of rear handle (G). If spring (J) is in an
upward direction, loosen bolts and retighten them.
18. Insert two plugs (A) to rear handle (G).
19. Insert collar (B) and (C) to intake bellows (L).
20. Assemble front handle and spring (Refer to “9-3
Replacing front handle and spring”).
21. Assemble purge bulb and fuel line (Refer to “4-6
Replacing purge bulb” and “4-7 Replacing fuel line
and fuel return line”).
22. Assemble carburetor (Refer to “4-15 Installing
carburetor”)
23. Assemble throttle control parts (Refer to “9-2
Replacing throttle control parts”).
24. Pass switch leads through rear handle (Refer
to “3-6 Replacing ignition switch).
L
M
G
j
J
g2
H
G
L
A
C
F
A
B
g3
J
J
g3
K
Содержание CS-2511TES
Страница 1: ...Ref No 401 40 CS 2511TES ECHO shindaiwa 251Ts 251TCs Serial number 37000001 and after...
Страница 87: ......
Страница 88: ...Published by YAMABIKO Corp Tokyo Japan 1610...