4
PLEASE NOTE: FVI12 IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT
NOTICE. PLEASE VISIT WWW.ECCOTEMP.COM/SUPPORT FOR MORE INFORMATION.
Support:
Eccotemp.com/help-desk
Shop Online:
Eccotemp.com/products
Store Locator:
Eccotemp.com/locator
Phone: 866-356-1992 | Email: [email protected] | Address: 315 - A Industrial RD Summerville, SC 29483
English
IMPORTANT SAFETY INFORMATION READ ALL INSTRUCTIONS BEFORE USING
DANGER!
WATER TEMPERATURE SETTING
Safety and energy conservation are factors to be considered when selecting the
water temperature setting. Water temperatures above 125°F can cause severe
burns or death from scalding. The thermostat is adjusted to its lowest temperature
position when shipped from the factory. Be sure to read and follow the warnings
outlined on the label pictured below.
The chart shown above may be used as a guide in
determining the proper water temperature for your
home.
DANGER: Households with small children, disabled,
or elderly persons may require a 120°F. or lower
temperature setting to prevent contact with”HOT” water.
Maximum water temperature occurs while burner is on.
To find water temperature being delivered, turn on a hot
water faucet and place a thermometer in the water stream
and read the thermometer.
The temperature of the water at the outlet of the water
heater can be regulated by setting the temperature on the
control panel. The control panel was set at 110°F before it
was shipped from the factory.
The illustration to the bottom left illustrates the control
panel and how to adjust the water temperature.
NOTICE:
When this water heater is supplying general
purpose hot water requirements for use by individuals, a
thermostatically controlled mixing valve for reducing point
of use water temperature is recommended to reduce the
risk of scald injury. Contact a licensed plumber or the local
plumbing authority for further information.
NOTICE:
The factory setting allows operating temperatures
between 90°F and 140°F.
NOTICE:
This is a manual water heater. This means that
the temperature must be set and regulated from the front
control panel on the water heater and
NOT
at your sink
or shower. Adjusting the water temperature from the sink
will lower the pressure activation point and turn the water
heater off.
DO NOT
adjust water temperature via your sink
or shower. You
MUST
adjust the temperature at the face
of the water heater using the control panel.
The FVI12 is
a pressure activated manually operated tankless water
heater.
Water Temperature
120°F
125°F
130°F
135°F
140°F
145°F
150°F
155°F
Time To Produce a Serious Burn
More than 5 minutes
1 1/2to 2 minutes
About 30 seconds
About 10 seconds
Less than 5 seconds
Less than 3 seconds
About 1 1/2 seconds
About 1 second
Time/Temperature Relationship in Scalds
Table courtesy of Shriners Burn Institute
Water temperature over 125°F can cause severe burns
instantly or death from scalds. Children, disabled and elderly
are at highest risk of being scalded. See instruction manual
before setting temperature at water heater. Feel water
before bathing or showering. Temperature limiting valves are
available, see manual.
SAFETY PRECAUTIONS
Safety