20
PLEASE NOTE: FVI12 IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT
NOTICE. PLEASE VISIT WWW.ECCOTEMP.COM/SUPPORT FOR MORE INFORMATION.
Support:
Eccotemp.com/help-desk
Shop Online:
Eccotemp.com/products
Store Locator:
Eccotemp.com/locator
Phone: 866-356-1992 | Email: [email protected] | Address: 315 - A Industrial RD Summerville, SC 29483
English
POWER CORD:
• The electric power supply requirement for this water heater is 120 VAC/60HZ, 2 Amps.
• The water heater comes with a three (3) pin power supply cord. Use only a power outlet
with a ground terminal.
• The installation of an electric leakage breaker is recommended. (GFCI)
• Keep any excess of the power supply cord on the outside of the water heater.
WARNING: Field wiring connections and electrical grounding must comply with local codes,
or in the absence of local codes, with the latest edition of the National Electrical Code,ANSI/
NFPA 70, or in Canada, Canadian Electrical Code, CSA C22.1Part1.
WARNING: Shock hazard line voltage is present. Before servicing the water heater, turn off the
electrical power to the water heater at the main disconnect or circuit breaker. Failure to do so could
result in severe personal injury or death.
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause
improper and dangerous operation. Verify correct operation after servicing.
Electric Wiring Diagram
Electrical Connection
Venting
CONTINUED...
Installation
