3
DOs & DON’Ts
Your Eccotemp is designed for easy maintenance.
AVOID
INSTALLATION IN CONFINED SPACES
. Allow at least 18 inches of
working space above and below your unit. Installing any water
heater in your attic or any other location that is not easily
monitored can result in unexpected property damage. Your
Eccotemp is so small and attractive, you should NEVER need to
install it in attics or areas difficult to monitor or service.
WHEN INSTALLING THE ECCOTEMP IN ANY AREA WHERE LEAKS
OF ANY NATURE COULD CAUSE PROPERTY DAMAGE OR ANY
OTHER AREAS THAT ARE NOT READILY VISIBLE OR ROUTINELY
MONITORED INCLUDING CLOSETS, CABINETS, ATTICS: A 150-PSI
MAXIMUM PRESSURE RELIEF VALVE WITH DRAIN LINE AND
A DRAIN PAN AND DRAIN LINE SUFFICIENT FOR CONTAINING
THE FLOW OF WATER PROVIDED BY THE SUPPLY LINE
MUST
BE INSTALLED.
WHEN LEAVING YOUR HOME FOR MORE THAN TWO DAYS, TURN
OFF THE SUPPLY WATER OR ALTERNATIVELY THE POWER TO
THE HEATER.
Your Eccotemp should require very little maintenance. In
areas of hard water, it is advisable annually, to remove its
detachable base plates and clean out any mineral deposits
from the chambers.
NEVER POUR OR SPRAY LIQUIDS DIRECTLY ON THE UNIT
THAT MIGHT ENTER THE CASE, POSSIBLY CAUSING DAMAGE
TO YOUR UNIT.
Your Eccotemp is designed for safe operation and ease of
service. Qualified service personnel must service your unit
only.
BEFORE YOUR UNIT IS TO BE SERVICED, ALWAYS TURN
OFF ALL MAIN, POWER CIRCUIT BREAKERS TO THE UNIT
. After
servicing, always
RUN WATER
through your unit before turning
the power on.
YOUR ECCOTEMP MUST BE INSTALLED AND SERVICED BY
QUALIFIED PERSONNEL. DAMAGE TO YOUR UNIT, SERIOUS
PERSONAL INJURY OR DEATH MAY OCCUR IF INSTALLED OR
HANDLED IMPROPERLY. CARE MUST ALWAYS BE USED TO AVOID
ELECTRICAL ACCIDENTS WHEN INSTALLING OR SERVICING.
NEVER USE PARTS THAT ARE NOT ORIGINAL EQUIPMENT OR
APPROVED ALTERNATE REPLACEMENT PARTS.
Protect your Eccotemp from the weather. It is an appliance, and
you must avoid installing this Eccotemp in unprotected areas
where it might be exposed to rain, excess humidity, freezing
conditions, etc.
Your Eccotemp is designed to operate ONLY when mounted
vertically. Do not attempt to mount any other way as
permanent damage to your unit will result with possible
catastrophic failure and significant water leakage.
Содержание ET-32
Страница 21: ...17 WIRING DIAGRAMS TWO CHAMBER SINGLE CIRCUIT...
Страница 22: ...18 WIRING DIAGRAMS TWO CHAMBER DUAL CIRCUITS...
Страница 23: ...19 WIRING DIAGRAMS FOUR CHAMBER DUAL CIRCUITS...
Страница 24: ...20 WIRING DIAGRAMS FOUR CHAMBER FOUR CIRCUITS...
