7
ECCOTEMP MOUNTING CLEARANCES
1
T
op Clearance
: For removal of heating elements and to provide room for plumbing
connections, a minimum of 12 inches is required.
2
Side Clearance
: Allow an overall minimum horizontal space for the heater of 24
inches for removal of protective cover screws and access to electrical wires
entering the heater from the side.
3
Mounting Height
: For safety, ease of installation and service, the suggested height
above the floor is 42 to 48 inches, (minimum 10 inches). Do not install electrical
disconnect or sub-panels below heater as this may interfere with access to the
clean out plates located under the heater.
4
Front Clearance
: In the absence of a door or removal access panel in front of the
heater, allow 32 to 36 inch clearance in front of the heater for protective cover
removal and ease of service.
Содержание ET-32
Страница 21: ...17 WIRING DIAGRAMS TWO CHAMBER SINGLE CIRCUIT...
Страница 22: ...18 WIRING DIAGRAMS TWO CHAMBER DUAL CIRCUITS...
Страница 23: ...19 WIRING DIAGRAMS FOUR CHAMBER DUAL CIRCUITS...
Страница 24: ...20 WIRING DIAGRAMS FOUR CHAMBER FOUR CIRCUITS...
