8
0
0
P
P
P
P
9
0
P
P
P
P
0
1
P
P
P
P
R
N
How to Delete ALL the users’ phone numbers
You can delete all the users’ phone numbers by sending SMS command as follows:
PPPP represent the four digits password.
The unit will reply by SMS that says: “
THIS IS A WARNING
.
Do you wish to DELETE all phone numbers?
“
If you wish to proceed, confirm it by sending SMS saying:
YES
The unit will send back SMS that say: “
All phone numbers were deleted
”.
=> Please NOTE
Ignoring the warning message and not confirming it by “ YES ” message within two minutes, will cause the system to
disregard the last command and the phone numbers would be saved and not be deleted.
3. Confirmation SMS service by the unit
The unit will reply by SMS message to each SMS command that was received to inform
the sender
if the command
SMS message that was received was
Confirmed
or
Failed
. This service can be cancelled so that the unit does not send
any SMS messages
EXCEPT for SMS command of Deleting all phone numbers
. The factory default setting is to send
SMS reply to the sender which would be, repeating the SMS message command sent, followed by the word
CONFIRMED or FAILED at the end of the message.
How to Cancel or Activate the SMS service in the unit
You can
Cancel
or
Activate
the SMS service of the unit by sending SMS command to the unit as follows:
The letters
PPPP
represent the four digits Password.
To cancel; send SMS
To Activate; send SMS
The unit will send confirmation SMS to the sender accordingly.
4. How to choose the number of Rings for the first three phone numbers
You can select the number of rings (from 1 to 9 rings) that the unit would wait for an answer, before it hangs up and
dials the 2
nd
and the 3
rd
phone numbers.
The factory default is 5 Rings (about 15 seconds) for each one of the first three phone numbers.
How to change the number of Rings by SMS command
You can change the number of Rings by SMS command for each of the three phone number in the system as follows:
The letters “ PPPP ” represent the 4 digit PASSWORD.
The letter “ N “ represents the number 1, 2, or 3 for the first, second and third phone number in the memory.
The letter “ R “ represents the numbers of Rings from 1 to 9. The factory default is 5.
Example:
The following SMS example shows how to program 7 Ring tones for the 3
rd
phone number in the memory:
The unit will send confirmation SMS to confirm accordingly.
