EC POWER XRGI 6, Инструкция по вводу в эксплуатацию

Страница: 44 / 50

42
XRGI® 20 COMMISSIONING INSTRUCTION VERSION 1.0 2019
TECHNICIAN MENU 1/1

Heat pumps

Configuration

Q-network statistics

Log

System info

IO status

Maintenance
TECHNICIAN MENU 1/1

Maintenance

Log

System info

Production

Heat pumps

Configuration

IO status
MAINTENANCE 1/1
OH until next maintenance:
Time to service:
System data and settings:
0 H
Delete
Confirm
Reset
OUTPUTS 3/3
Running:
Alarm:
Generator:
Heat pump 2:
Power factor correction:
Heat pump 1:
ON
OFF
OFF
OFF
OFF
OFF
INPUTS 2/3
G59 relay:
No start:
Forced standby:
Fire alarm:
OK
INACTIV
OK
INACTIV
INPUTS 1/3
Aux alarm:
Gas alarm:
Prot.eng. switch:
T1:
T2:
T2:
Oil pressure:
OK
OK
NO PRESSURE
COLD
COLD
COLD
OK
6.2.4 M A I N T E N A N C E
6.2.5 I O S TAT U S
■
In the technician menu, move the cursor to Maintenance by using the
▲▼
buttons and press
OK
on the user interface.
■
While the cursor is on
Reset
, press
OK
on the user interface to activate the field.
■
Move the cursor to
Confirm
by using the
▲▼
buttons and press
OK
on the user
interface. The correct maintenance interval for the XRGI® system will be displayed.
TECHNICIAN MENU 1/1

Log

System info

IO status

Heat pumps

Configuration

Q-network statistics

Production
PRODUCTION 1/3
Current production:
Total:
Generator:
Desired production:
Fuel step:
Power step:
0.0 kW
3 Wh
0
0
0.0 kW
On
Injector: 0
6.2.6 P R O D U C T I O N
■
In the technician menu, move the cursor to
Production
by using the
▲▼
but-
tons and press
OK
on the user interface.
C H E C K I N G T H E D I R E C T I O N O F R O TAT I O N
■
While the cursor is on
Generator
, press
OK
on the user interface to start the
generator.
Check the status of the in- and outputs of the XRGI® system. The inputs should display
the status
OK
to enable the XRGI® system to start. If they do not, errors have to be elim-
inated on the ECU circuit board; the wiring between the Power Unit and iQ-Control
Panel may be faulty or an external control or switching operation may be preventing
the start-up of the Power Unit.
■
In the technician menu, move the cursor to
IO Status
by using the
▲▼
buttons
and press
OK
on the user interface.
■
Check the status of the in- and outputs.
■ Switch between pages by using the
▲▼
buttons.