Chengdu Ebyte Electronic Technology Co.,Ltd.
E180-ZG120A User Manual
Copyright ©2012–2019, Chengdu Ebyte Electronic Technology Co.,Ltd.
1
configuration also needs to be clicked. Write the parameters after modifying the network parameters, and finally restart to
join the new ZigBee network
7.3 ZigBee Network communication test
7.3.1 Unicast test
7.3.1.1 Unicast between end-device and coordinator in the form of short address
Enter the configuration mode, configure the target network address, and modify the target network address of the coordinator to
the local short address (0xFCFA) of the end-device. The destination network address of the end-device is 0 by default. 0 is the
coordinator's network short address (the coordinator's network short address is always 0). It does not need to be modified at this time.
If the end-device communicates with the non-coordinator node, it needs to be modified (modified to the destination node's network
local short address).
（
2
）
After the target address between nodes is configured, click "enter transmission mode", and the message box will prompt
"enter transmission mode successfully". Before communication, confirm whether the module is in transmission mode, and only in the
transmission mode can the communication be realized. Input the data to be sent in the sending area, click send, and the received data
can be seen in the end-device node message box.
